BatteryMINDer® Model 244CEC2-XLR2: 24V 1/2/4 AMP Charger-Maintainer-Desulfator for Everest & Jennings Power Chairs & Mobility Scooters & Lithium Charger Maintainer

• Guaranteed to never overcharge/undercharge. (33°F to 130°F)
• Push-button Selection for ALL battery types and charge rates.
• 100% Full - Time U.S. Patented Pulse-type Desulfation keeps Lead Acid battery free of sulfate or dissolves sulfate completely in older batteries.
• Detects and rejects batteries with bad cells.
• Maximize battery life and capacity, recovers weak batteries.
• Diagnoses battery’s condition / state-of-charge.
• Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
• Maintain up to 8 batteries at a time. (requires BatteryMINDer® Y-Connector Accessory 210-AY)
• Auto-Restart after power failure.
• Intrusion protected from water and dust per IEC STANDARD IP65.
• Bad cell detection with auto-shutdown.

• Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
• Very high efficiency. California CEC Approved.
• Automatically detects input AC power.
• ECO-mode with hi-efficiency / low power consumption.
• Ambient temperature compensation. Built-in temperature sensor  automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)
• 18 LED indicators show state-of-charge and important status mode / battery condition.
• Rugged, vibration-resistant construction.
• Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.

• Model 244CEC2 Charger-Maintainer-Desulfator
• REVERSE POLARITY XLR Connector that matches EVEREST & JENNINGS Power Chairs & Mobility Scooters
• 6' AC cord, 6' DC cord with quick connector (SAE)
• Auto-Temp Compensation Sensor (installed)
• Insulated Battery Clip Cord Set with Quick Connector and 15A replaceable fuse
• Ring Terminal Cord Set with Quick Connector
• Ring Terminal Assembly and 15A replaceable fuse

Click Here To View The Instruction Manual
(PDF opens in a new window)
Please note that you need Adobe Acrobat Reader to view the file.
If you do not have it, CLICK HERE to install it.

• 210AY: Y Multiple Battery Connector
• 210RT: Y Multiple Battery Connector w/ Ring Terminal Connector
• ABS-248: At the Battery Temperature Sensor
• ATS-1: Ambient Temperature Sensor
• BC-AA: Insulated Battery Clip Cord Set
• BC2AY:  Insulated Battery Clips w/ 210AY Y Multiple Battery Connector
• DCE12: DC Extension Cables - 12ft.
• DCE25: DC Extension Cables - 25ft.
• EZC-01: EZ Connector and Mounting Screws
• EZC-RT: EZ-Connector & Ring Terminal Assembly w/ Mounting Screws
• RTA-2415: 2’ Ring Terminal Assembly w/ Quick Connector
• RTA-7215: 6’ Ring Terminal Assembly w/ Quick Connector
• VPP-12: 12/24 Volt Vehicle Power Plug